#
Select ´ and adapt an existing departure
time.
Setting repeat days
#
Select Add New Timeand set the time.
#
Mark the relevant weekdays to which the
departure time will apply and conrm with
a.
or
#
Select ´ and edit existing repeat days.
Setting a break in the charging process
Up to four breaks in the charging process can be
set during which the vehicle is not charged, even
if it is connected to a charging station.
#
Select Charging Pauses.
#
Select Add New Time and then set and save
the times for the beginning and end of the
break.
#
Activate or deactivate the charging breaks that
have been set.
Set charging breaks can be edited with the ´
button or deleted with the E button.
Setting the maximum state of charge
#
Select Maximum State of Charge.
#
Set the desired percentage.
The high-voltage battery will be charged up to
no higher than the set percentage.
%
The percentage can be set in increments of
10%.
%
As soon as the maximum state of charge is
reached, a notication will be shown on the
central display stating that the charging proc-
ess is complete and you may continue your
journey.
Calling up the energy ow display
Multimedia system:
4
©
5
Info
#
Select Energy Flow.
The energy ow in the vehicle will be dis-
played.
Information on the status of the hybrid system
and the current state of charge of the high-voltage
battery will be displayed in addition to the energy
ow.
Navigation and trac
Notes on navigation
Route guidance with augmented reality
&
WARNING Risk of accident and injury as a
result of distraction, incorrect depiction or
wrong interpretation of the display
The camera image of the augmented reality
display is not suitable as a guide for driving.
#
Always keep an eye on the actual trac
situation.
#
Avoid extended observation of the cam-
era image.
370
MBUX multimedia system
To Next Page
Loading...
Need help?
General
