SMART TACH & SPEED
4-6
SMART TACH & SPEEDOMETER
gog95
TROLL
+
TROLL
–
TROLL
+
TROLL
–
Speedometer
Tachometer
Actual Speed
Set Speed
Actual Speed
Set Speed
TR
a
oso6
Troll Control
Basic Operation
With troll control you can maintain a trolling speed of 550 to1000 rpm
without using the throttle. See NOTE: following.
NOTE:Avoid using a very low rpm trolling speed for an extended peri-
od of time. Doing so could result in a low-battery voltage condition.
You can set the troll control by using either the tachometer or
speedometer. Tachometer will set the speed in RPM and speedom-
eter will set the speed in MPH.
You can shut off troll control anytime by pushing the
MODE
button
when in the troll display screen or moving the throttle.
If you have troll control set at a desired speed and then you shut off
the troll control, the system remembers the set speed and will return
to that speed when re-engaged.
The display screen will revert back to the previous screen after 10
seconds of no activity. Push the
TROLL
+
or
TROLL
–
button to reactivate
the display screen.
When the troll control is engaged and you are out of the troll control
screen, a flashing signal “TR” (a) will appear in the upper left corner
of the display to indicate troll control is still running.
To Next Page
Loading...
Need help?
General
