Metrohm PGSTAT302N User Manual

Insert new module for the Autolab 8-Series
17 | Page
c. Connect I-PGSTAT of the BA to FRA I of the PGSTAT.
7. Connect the SMB to 4 mm banana cable, labelled WE2, to the dedicated plug on
the Autolab differential amplifier.
10.2 – If the FRA32M module is present
For the BA module the SMB coaxial cables should be connected as shown in Figure 16.
Figure 16 – Overview of the SMB cables required between the BA module and the PGSTAT and
optional FRA32M module
8. Disconnect the three SMB cables between the FRA32M and the PGSTAT and
reconnect these cable to the BA module:
a. Connect PGSTAT U of the FRA32M to E-FRA of the BA.
b. Connect PGSTAT I of the FRA32M to I-FRA of the BA.
c. Connect PGSTAT DSG of the FRA32M to FRA-DSG of the BA.
9. Connect the special copper labelled SMB cable between the WEx of the BA
module and the BIPOT WE2 of the PGSTAT. Please note that the location of BIPOT
WE2 on the PGSTAT differs slightly depending on the model (see Figure 16).
10. Connect the three additional SMB cables:
a. Connect To PGstat of the BA to DSG of the PGSTAT.
b. Connect E-PGSTAT of the BA to FRA E of the PGSTAT.
c. Connect I-PGSTAT of the BA to FRA I of the PGSTAT.

Metrohm PGSTAT302N Specifications

General

Brand	Metrohm
Model	PGSTAT302N
Category	Measuring Instruments
Language	English