C
ONNECT DRAIN HO
SE T
O HOME PL MBING
1. Grasp the sides of the dishwasher at the edges of the door panel, and
place the dishwasher in front of the opening.
2. Insert the drain hose into the hole in the cabinet wall.
3. Attach drain hose to the back of the dishwasher and secure with a
hose clamp.
b
c
e
d
a
Insulation Blanket
b
Water Line
c
Drain Hose
(Maximum Length
10 ft [3.0 m])
d
House Wiring
e
Power Cord (If
Used)
SLIDE DISHWASHER PARTIALLY INTO OPENING
WARNING
T
ip Ov
er Hazar
d
•
Do not use dish
w
asher until c
omplet
ely ins
talled.
•
Do not push do
wn on open door
.
•
Doing so can r
esult in serious injury or cuts.
1. P
osition po
w
er supply
.
•
If dishwasher has a power supply cord, insert power supply cord
into the hole cut into the cabinet.
•
If using a direct-wire connection, check that the wiring is on the
right front side of opening.
2. Make sure the drain hose is not kinked under the dishwasher and
there is no interference with the water line and wiring or any other
component.
3. Slowly move the dishwasher into the opening a few inches at a time.
As you proceed, pull the drain hose, water supply hose and cord
through the opening under the sink or cabinet. Stop pushing when the
dishwasher is a few inches in front of the adjacent cabinetry.
a
U
Safety
Precautions
Installation
Requirements
Installation
Instructions
20
To Next Page
Loading...
Need help?
General
