5. Check for leaks under the dishwasher. If a leak is found, turn power and
water supply off, then tighten connections. Restore power after leak is
corrected.
6. Check for leaks around the door. A leak around the door could
be caused by door rubbing or hitting against adjacent cabinetry.
Reposition the dishwasher, if necessary.
7. When the dishwasher is draining, check the drain lines. If leaks
are found, turn power off at the breaker and correct plumbing as
necessary. Restore power after corrections are made.
8. Open dishwasher door and make sure most of the water has drained.
If not, check that disposal plug has been removed and/or air gap is not
plugged. Also check drain line for kinking.
9. Run the dishwasher through another fill and d ain cycle. Check for
leaks and correct, if needed.
REPLACE THE KICK PLATE
1. Place the kick plate against the legs of the dishwasher. The slots in the
kick plate should align with the screw holes in the bracket. Allow the
bottom edge of the kick plate to touch the floo .
2. Using screws (provided), fasten the kickplate to the dishwasher.
Safety
Precautions
Installation
Requirements
Installation
Instructions
34
To Next Page
Loading...
Need help?
General
