Water softening
The water softener must be adjusted manually with the help of the water hardness regulator. Water
softener to remove minerals and salts that can adversely affect the operation of the device. The more
minerals the water contains, the "harder" it is.
The softener should be adjusted according to the hardness of the water in your area.
Ask your local water supply company for information on the hardness of your water.
Adjustment of salt consumption
The washing machine has the function of adjusting salt consumption according to the hardness of
the water. Thus, salt consumption is optimized and adjusted.
Please follow the steps below to adjust the salt consumption.
1.Open the door and turn on the device;
2.Press the Program button for more than 5 seconds to start the water
softener adjustment within 60 seconds after pressing the power button;
3.Press the Program button to select the appropriate setting according to the hardness of your water.
The settings are changed in the following order:
H3->H4->H5->H6->H1->H2->H3;
4.Leave the device idle for 5 seconds or press the power button to complete
the setup and exit the setup function.
WATER HARDNESS
Level
softener
water
It regenerates
takes place every X
programmatic
sequences1)
Salt consumption
(gram/cycle)
German
dH
French
fH
British
Clarke
Mmol/l
0 - 5
6 - 11
12 - 17
18 - 22
23 - 34
35 - 55
0 - 9 0 - 6
0 - 0.94
H1
No regeneration
0
9
12
20
30
60
10 - 20 7 - 14
1.0 - 2.0
H2
10
21 - 30 15 - 21
2.1 - 3.0
H3
5
31 - 40 22 - 28
3.1 - 4.0
H4
3
41 - 60 29 - 42
4.1 - 6.0
H5
2
61 - 98 43 - 69
6.1 - 9.8
H6
1
1°
dH=1.25° Clarke=1.78° fH=0.178mmol/l
Factory setting:H3
1)Each cycle with the regeneration process consumes an additional 2.0 liters of water, increases
energy consumption by 0.02 kWh, and increases the duration of the program by 4 minutes.
6
To Next Page
Loading...
Need help?
General
