Changing the program while the cycle is in progress
The wash cycle can only be changed if it has been started for a short time, otherwise the
detergent has already been released and the washing machine may have already drained the
wash water. In this case, the dishwasher should be reset and the detergent tank refilled. To
reset the dishwasher, follow the instructions below:
1.Open the door slightly to stop the dishwasher so you can open it fully after
the sprayer stops running.
2.Press the Program button for more than three seconds, because the device will be in standby
mode.
3.You can change the program to the desired cycle setting.
3 sec
You forgot to put a certain dish ?
You can add forgotten dishes at any time before the detergent starts to
dispense. In that case, follow the instructions below:
1.Open the door slightly to stop the wash.
2.When the sprinklers stop turning, you can open the door all the way.
3.Add dishes.
4.Close the door.
5.The washing machine will continue to work.
WARNING
It is dangerous to open the door during
washing, because the hot water could
burn you.
15
To Next Page
Loading...
Need help?
General
