^
When removing the filters for
cleaning, also clean off any residues
of oil or fat from the now accessible
housing to prevent the risk of these
catching fire.
When putting the grease filters back in
position, ensure that the locking clips
are facing down towards the hob.
^ If a grease filter is inadvertently
replaced upside down, insert a small
screwdriver blade into the slit to
disengage the clip.
^ After replacing the grease filters,
press the grease filter control for
approximately 3 seconds to reset the
operating hours counter.
The indicator lamp will go out.
^
If the grease filters are cleaned
before the operating hours counter
has reached its maximum, the grease
filter control should be pressed for
approximately 6 seconds to reset the
counter.
Fitting and replacing the
charcoal filters
If the cooker hood is connected for
recirculation, charcoal filters must be
inserted in addition to the grease filters.
They are designed to absorb cooking
odours and are fitted in the canopy
above the grease filters.
DA 2250, DA 2270: 2 charcoal filters
DA 2210: 4 charcoal filters
New filters can be purchased from
your Miele dealer or from the Miele
Spare Parts Department.
See back cover for contact details,
and "Technical data" for the model
number of the filter.
^ Before fitting or replacing the
charcoal filters, the grease filters
must first be taken out (see previous
section for instructions on how to do
this).
^ Unwrap the charcoal filters.
^
Insert the charcoal filters into the
canopy.
^
When fitting for the first time:
Activate the charcoal filter operating
hours counter to suit your
requirements (see "Operation").
^
Replace the grease filters.
Cleaning and care
22
To Next Page
Loading...
Need help?
General
Weight and Dimensions
