Connecting valve
The connecting valve on the water con
-
tainer consists of a valve insert t,
a rubber pad u and an O-Ring v. The-
re is also a connecting valve on the ap-
pliance itself, this however only consists
of the valve insert t.
The connecting valve or parts of it may
need replacing if
– an unusually large amount of water is
collecting in the bottom of the appli-
ance where the water container con-
nects into the valve on the appliance.
–
an audible tone is sounding and the
symbol for insufficient water is lit up,
even though the water container is
full and located correctly.
Visually check the connecting valves
for obvious wear and tear. If it is not ob
-
vious which part is faulty replace the
valve inserts t in the water container
and in the appliance. If the fault is still
not corrected then replace the O-Ring
v and the rubber pad u in the water
container connecting valve.
To replace the valve insert t :
^
Insert the pointed end of the special
tool (see Accessories at the begin
-
ning of this book) into the valve insert
and pull it out:
of the water container
of the appliance
Cleaning and care
50
To Next Page
Loading...
Need help?
General
