Technical Information
23
G 1xxx/G 2xxx
Function Programming Display
Country setting
2
Press the options button
39x. The “Tab” LED
flashes 3x slowly and 9x
quickly intermittently.
Press the Program button
as appropriate to make the
desired setting.
The display shows p and a digit
alternately. The following countries
can be set: p1 = EUR (Europe); p2 =
AUS (Australia); p3 = USA; p4 =
JPN (Japan); p5 = I/E (Italy/Spain);
p6 = SER (Southern Europe).
3
Table 13: Service Programming Mode, G 1472/G 2472
1
In machines with software version -876, run the update “Optimized cleaning of tea
residues in Sensor Wash program” (mat. no. 06471560). Modified threshold values will
improve the cleaning outcome.
2
If the electronic needs to be replaced during servicing, the following steps must be taken
during programming: In the first step, set the country specification and model, then switch
off the appliance. Repeat access and then set appliance width and height, and the
appropriate supply water hardness.
3
The SER country specification includes the following countries: Portugal, France, the
Netherlands, Belgium and Great Britain.
Save and quit:
Switch off the appliance.
Water Hardness [°d] Water Hardness [gpg] Display
1 1.1
P1
2 2.1
P2
3 3.2
P3
… … …
36 38.5
P36
37 – 50 39.6 – 53.5
P50
51 – 60 54.6 – 64.2
P60
61 – 70 65.3 – 74.9
P70
Table 14: Water Hardness Settings, G 1472/G 2472
Note:
If the dishwasher is connected to an external ion exchanger water softener (i.e.
that needs to be regenerated with salt), the water hardness delivered by the
system must be set. If this value is unknown, set to 8°d (8.6 grains per gallon).
2.6 Advanta - G 2020
Initial requirements:
1. Close the door.
2. Switch off the appliance.
3. Turn the selector switch to the 12 o'clock position.
Accessing:
1. Press and hold the Start/Stop button.
2. Switch on the appliance.
To Next Page
Loading...
Need help?
General
