Technical Information
36
G 1xxx/G 2xxx
Water Hardness [°d] Water Hardness [gpg] Display
1 1.1
P1
2 2.1
P2
3 3.2
P3
… … …
36 38.5
P36
37 – 50 39.6 – 53.5
P50
51 – 60 54.6 – 64.2
P60
61 – 70 65.3 – 74.9
P70
Table 25: Water Hardness Settings, G 2420/G 243x
Note:
If the dishwasher is connected to an external ion exchanger water softener
(i.e. that needs to be regenerated with salt), the water hardness delivered
by the system must be set. If this value is unknown, set to 8°d (8.6 grains
per gallon).
2.10 Excella - G 2630/G 2670
Initial requirements:
1. Close the door (open for G 2670).
2. Switch off the appliance.
Accessing:
1. Press and hold the C (clear) button.
2. Switch on the appliance.
3. Release the C (clear) button when the display lights up.
4. Immediately press the C (clear) button 5 times; on the 5th time, hold for
at least 4 seconds.
Acknowledgement indicator:
Successful accessing of the programming mode is indicated by the LEDs,
which are all off, and Service programming, in the top line of the display.
The display always indicates three parameters at a time.
Use the cursor buttons to scroll through the display.
Options:
Note:
Some of the following parameters can also be programmed via the Settings menu.
To Next Page
Loading...
Need help?
General
