Settings
31
Rinse Aid
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from 0
to 6ml.
3ml is the factory default setting.
The rinse aid dosage can turn out to be
higher than the set value due to the
automatic adjustment of the program.
If spots appear on dishware:
- Increase the rinse aid dosage.
If clouding or smearing appears on
dishware:
- Decrease the rinse aid dosage.
Display brightness
You can set the display brightness to
one of 7 different levels.
Buzzer
A sequence of buzzer tones will sound
at the end of the program or if there is a
fault, as long as the buzzer has been
activated.
The buzzers at the end of a program
and the alarm tone in the event of a
fault will sound 4 times at intervals with
a short pause between each set.
You can deactivate the buzzer that
sounds at the end of a program if you
wish.
The alarm tone that sounds when
there is a fault cannot be
deactivated.
To Next Page
Loading...
Need help?
General
