Problem solving guide
77
Poor cleaning results
Problem Possible cause and solution
The dishware is not
clean.
The dishware was not loaded correctly.
See notes under “Loading the dishwasher”.
The program was not powerful enough.
Select a more powerful program (see “Program
overview”).
Activate the Extra clean function (see “Extra clean”
under “Settings”).
Activate the “Second interim rinse” function (see
“Settings – Second interim rinse”).
Not enough detergent was dispensed.
Use more detergent during manual dispensing or
change the detergent you are using.
Increase the dispensing quantity during automatic
dispensing (if available) (see “Settings – AutoDos”).
Items are blocking the path of the spray arms.
Carry out a rotation check and if needed rearrange
the items so that the spray arms can rotate freely.
The filter combination in the wash cabinet is not
clean or was incorrectly fitted.
This may have caused the spray arm jets to become
blocked.
Clean and/or fit the filter combination correctly.
Clean the spray arm jets if necessary (see
“Cleaning the spray arms” under “Cleaning and
care”).
There are smears on
glassware and cutlery.
There is a bluish sheen
on the surface of
glassware. The film can
be wiped off.
The rinse aid dosage is set too high.
Reduce the dosage (see “Rinse aid” under
“Settings”).
To Next Page
Loading...
Need help?
General
