Operation
51
End of program
At the end of a program, the in-
operation indicator light will be flashing
slowly with the door shut. The buzzer
might also be sounding.
The in-operation indicator light will go
out 10minutes after the end of the
program if the door is closed.
The program has ended when the
display shows the message Ready.
In some programs, if the AutoOpen
function is activated, the door will
automatically open slightly (see
“AutoOpen” under “Settings”). This
improves the drying process.
The drying fan may continue to run for
a few minutes at the end of the
program.
Risk of damage due to steam.
Steam from the dishwasher could
damage the edges of delicate
countertops when you open the door
at the end of the program and the
blower is no longer running.
If you have deactivated the
automatic door opening function (see
“AutoOpen” under “Settings”), but
would still like to open the door at
the end of the program, then make
sure that you open the door fully.
Energy management
To save energy, the dishwasher will
switch off automatically 10minutes
after the last time a button is pressed or
after the end of a program.
You can turn the dishwasher back on
again with the button.
The dishwasher will not turn itself off
while a program is running or if there is
a fault.
To Next Page
Loading...
Need help?
General
