Problem solving guide
72
Water intake fault
Problem Possible cause and solution
The in-operation
indicator light is
flashing quickly.
The alarm tone is
sounding.
One of the following
messages appears in
the display:
Open water supply The water supply is turned off.
Turn on the water supply fully.
Intake Before remedying the fault:
Switch the dishwasher off.
There is a problem with the water intake.
Turn on the water supply fully and start the
program again.
Clean the filter in the water intake (see “Cleaning
the filter in the water intake” under “Cleaning and
care”).
The water connection pressure is lower than
50kPa.
Seek professional advice.
The on-site connection for the water drainage may
be too low and you will need to vent the water
drainage (see “Water drainage” under
“Installation”).
Fault F18 A technical fault has occurred.
Switch the dishwasher off.
Turn off the water supply.
Contact Miele Service.
To Next Page
Loading...
Need help?
General
