Before using for the first time
25
Setting the time
The time is updated automatically if a
connection is established with the
WiFi network.
The display will then change to the
screen for setting the time.
The current time of day must be set be-
fore you can use the timer option.
Use the sensor buttons to enter
the hour and confirm your entry with
OK.
Then set the minutes and confirm
with OK.
Keeping the relevant or sensor
button pressed will increase or de-
crease the time automatically.
Setting the water hardness
The display changes to the screen for
setting the water hardness.
- The dishwasher must be pro-
grammed to the correct water hard-
ness for your area.
- Your local water authority will be able
to advise you of the water hardness
level in your area.
- Where the water hardness fluctuates,
e.g., between 10-16 gpg (10–15°dH),
always program the dishwasher to
the higher value (16 gpg (15°dH) in
this example).
It is useful to know your water hardness
so that you can provide the service
technician with this information in the
event of any service calls.
Enter the water hardness below:
____________gpg (°dH)
The dishwasher is programmed at the
factory for a water hardness level 1 gpg
(1°dH).
Set the water hardness level in your
area and confirm with OK.
See “Water hardness” under “Set-
tings” for more information.
To Next Page
Loading...
Need help?
General
