Cleaning and care
85
Cleaning the control panel
The control panel should only be
wiped with a damp cloth.
Cleaning the reflector panel
The reflector panel for the in-operation
indicator light is situated on the cover
sheeting underneath the countertop.
The reflector panel should only be
cleaned with a damp cloth if neces-
sary.
Cleaning the front of the ma-
chine
Damage due to soiling.
Soiling that is left too long might be-
come impossible to remove and
could cause the external surfaces to
alter or discolor.
It is therefore best to remove any
soiling immediately.
Clean the appliance front with a clean
soft sponge and a solution of warm
water and liquid dish soap. After
cleaning, wipe the surfaces dry using
a soft cloth.
A clean, damp microfiber cloth with-
out detergent can also be used.
To avoid damaging the external sur-
faces, do not use the following:
- cleaning agents containing soda, am-
monia, acids, or chloride
- cleaning agents containing lime scale
remover
- abrasive cleaning agents, such as
scouring powder, scouring liquid, or
pumice stones
- cleaning agents containing solvents
- stainless-steel cleaning agents
- dishwasher cleaner
- oven cleaner
- glass cleaner
- hard, abrasive brushes or sponges,
e.g., pot scourers, brushes, or
sponges which have been previously
used with abrasive cleaning agents
- eraser sponges
- sharp metal scrapers
- steel wool
- steam cleaners
To Next Page
Loading...
Need help?
General
