Installing the appliance
^ Push the oven into the building-in
niche as far as the wooden
blocks/transport protectors h. When
doing so make sure that the
connection cable cannot get trapped
or damaged.
^
Remove the wooden blocks/transport
protectors h from the base of the
oven on the right and left hand side
(see illustration) and then push the
appliance into the building-in niche
until it is up against the back panel of
the housing unit.
After aligning the appliance it must be
secured in the housing unit.
^
Fit fixing screws i into the vertical
trim on the left hand side of the
appliance as shown in the illustration.
^ Using the Operating Instructions as a
guide, check all oven functions are
working correctly.
Installation
64
To Next Page
Loading...
Need help?
General
