Programming the water hardness
level
^
Switch the dishwasher off with the
On/Off button I-0.
^
Press the +c and h/f buttons and
whilst holding them in switch the
dishwasher on with the On/Off button
I-0.
^
Then release these buttons.
The "Main wash/Rinses" l indicator
light will come on.
The "Salt" k indicator light will flash.
If this does not happen, start the proce-
dure from the beginning again.
If the following flashes in the timer dis-
play: a19
The water hardness level has been set
to 2.5 mmol/l (19 °d).
^
Use the programme selector buttons
%$ to select the value that corre
-
sponds to your water hardness level
(see chart on the right).
Use the % button to scroll down and
select a lower value.
Use the $ button to scroll up and in
-
crease the value.
The value selected will appear in the
display.
A two digit value flashes in the display
with one figure alternating with the ot
-
her.
^ Press the Start/Stop button h/f twi-
ce.
The indicator light beside the h/f but-
ton will flash.
The programmed water hardness level
is now stored in memory.
^ Switch the dishwasher off with the
On/Off button I-0.
Before using for the first time
16
To Next Page
Loading...
Need help?
General
