As the salt reservoir is filled, displaced
water will overflow.
^
Clean any excess salt from around
the reservoir opening and then screw
the cap on again firmly.
^
Run the COLD I programme imme
-
diately to remove any traces of salt
water from the cabinet.
Salt indicator
The salt indicator light comes on to noti
-
fy you that the reservoir is empty.
^
The reservoir should then be refilled
with dishwasher salt.
(See: Filling the salt reservoir).
After the reservoir has been filled, the
water softener is automatically reacti
-
vated the next time the dishwasher is
run. The salt indicator light may still be
illuminated during this process. It will
go out once the salt concentration has
reached the correct level.
Note
If the water in your area is very soft and
constantly lower than 0.7 mmol (4 °d)
you do not need to add salt to the re
-
servoir.
The salt indicator light, however, will still
come on, but should be ignored.
The salt refill indicator light is also used
as a programming interface point by
service technicians. See "After sales
service" for details of this.
Before using for the first time
19
To Next Page
Loading...
Need help?
General
