Operation
43
Starting a program
Start the program by closing the
door.
The program starts.
The in-operation indicator comes on to
show that a program has been started.
A program should only be canceled
in the first few minutes, if at all. Im-
portant program stages could other-
wise be omitted.
Time display
The estimated duration of the program
selected appears in hours and minutes
in the display before the program be-
gins. During the program, the time left
until the end of the program is dis-
played.
Each program phase is indicated by a
symbol:
Pre-wash / Soak
Main wash
Interim rinse
Final rinse
Drying
End
The displayed program duration may
vary with the same program. It is influ-
enced by, among other things, the wa-
ter temperature at each intake, the re-
activation process of the water softener
and the amount of dishes.
The times shown in the program guide
refer to standard test loads and temper-
atures.
Each time a program is run, the elec-
tronic module calculates the program
duration required depending on the
temperature of the water taken into the
dishwasher and the amount of dish-
ware.
To Next Page
Loading...
Need help?
General
