Frequently asked questions
74
Faults with water intake or drainage
Problem Possible cause and solution
One of the following
fault messages is dis-
played:
Open water supply The faucet is closed.
Open the faucet completely.
Intake Before remedying the fault:
Turn the dishwasher off with the button.
There is a problem with the water intake.
Open the faucet completely and start the program
again.
Clean the water intake filter (see “Frequently asked
questions”).
The flow pressure at the water connection is lower
than 30kPa (0.3bar).
Consult a plumber.
The following fault mes-
sage appears in the dis-
play:
Drain
Before remedying the fault:
Turn the dishwasher off with the button.
Water drainage fault.
There might be water in the wash chamber.
Clean the filter combination (see “Cleaning and
care – Cleaning the filters”).
Clean the drain pump (see “Frequently asked
questions”).
Clean the non-return valve (see “Frequently asked
questions”).
Remove any kink or loop in the drain hose.
To Next Page
Loading...
Need help?
General
