Frequently asked questions
123
Water inlet and drainage
Problem Possible cause and solution
Check water intake One or more faucets are turned off.
Turn on the faucets.
There was insufficient water in the machine.
Clean the water intake filters.
Turn on the faucets fully.
Flow pressure at the water connection is less than 4.35 psi
(0.3 bar/30 kPa).
Contact a qualified plumber.
Noises
Problem Possible cause and solution
There is a knocking noise
in the wash cabinet.
One or more spray arms are knocking against the wash
load.
Cancel the program. To do this, follow the instructions in
“Canceling a program.”
Arrange the wash load so it cannot obstruct the spray
arms.
Make sure the spray arms are not obstructed.
Start the program again.
There is a rattling noise in
the wash cabinet.
Items are not properly secured in the wash cabinet.
Cancel the program. To do this, follow the instructions in
“Canceling a program.”
Rearrange the load so that items are secure.
Start the program again.
Knocking noise in the wa-
ter pipes.
This may be caused by the on-site installation or the cross-
section of the piping. It has no affect on the function of the
machine.
Contact a qualified plumber.
To Next Page
Need help?
General
