Frequently asked questions
138
Cancel with fault code
If a program is canceled and a fault code appears, e.g., Fault XXX (where XXX represents a
number), there could be a serious technical fault.
In the event of a program being canceled and a fault code being shown:
Use the button to switch the machine off.
Wait approximately 10seconds before switching the machine on again with the but-
ton.
Acknowledge the fault code by entering your PIN code.
Start the previously selected program again.
If the same message appears again:
Make a note of the fault message.
Use the button to switch the machine off.
Contact Miele Service.
Please also read the notes regarding the following fault codes.
Problem Possible cause and solution
Fault 403-405 A program has been canceled because water intake by the
machine was insufficient or severely restricted.
Turn on the faucets fully.
Follow the further information provided in the Check wa-
ter intake message.
Fault 406–408 A program was canceled because the water flow rate is in-
sufficient.
Check whether the faucets are fully turned on.
Refer to the information regarding minimum flow pres-
sure in “Connection to the water supply” and “Technical
data”.
Check the filters in the water supply.
In this instance, please contact Miele Service for advice.
Fault 412–414 A program was canceled because the water flow rate is too
high.
Refer to the information regarding recommended maxi-
mum flow pressure and maximum permissible static wa-
ter pressure in “Connection to the water supply” and
“Technical data”.
In this instance, please contact Miele Service for advice.
Fault422 The salt supply in the water softener has been used up.
Reactivation is no longer possible. The machine will be
locked for further use with the next reactivation.
Refill with reactivation salt.
To Next Page
Loading...
Need help?
General
