Application technology
40
Preparing the load
Only items which have been declared by their manufacturer as
suitable for machine reprocessing may be processed. The manu-
facturer's specific reprocessing instructions must be observed.
Special injector nozzles, irrigation sleeves or adapters may be re-
quired for appropriate internal cleaning, depending on the load.
These, together with other accessories, are available from Miele.
- Arrange the wash load so that water can access all surfaces. This
ensures that it gets properly cleaned!
- Do not place items to be cleaned inside other pieces where they
may be concealed.
- Hollow items must be thoroughly cleaned, internally and externally.
- Ensure that items with long narrow hollow sections can be flushed
through properly before placing them in a fitting or when connect-
ing them to a water connection.
- Hollow vessels should be inverted and placed in the correct mobile
units, baskets, modules and inserts to ensure that water can flow in
and out of them unrestricted.
- Deep-sided items should be placed at an angle to make sure water
runs off them freely.
- Tall, narrow, hollow items should be placed in the center of the bas-
kets or units if possible to ensure better water coverage. or units if
possible to ensure better water coverage.
- Take apart any items which can be dismantled according to the
manufacturer's instructions and process the individual parts sepa-
rately from each other.
- Lightweight items should be secured with a cover net (e.g. an A 6)
and small items placed in a mesh tray to prevent them blocking the
spray arms.
- The spray arms must not be blocked by items which are too tall or
which hang down in their path.
- Broken glass can result in serious injury when loading or unloading.
Broken glass items must not be processed in the machine.
- Nickel- and chrome-plated items and items made of aluminum re-
quire special procedures and are not generally suitable for machine
reprocessing. are not generally suitable for machine reprocessing.
- When cleaning items that are made entirely or partially out of plas-
tic , the maximum thermal stability of the item must be considered.
Select an appropriate program or adjust the temperature of the pro-
gram accordingly.
Observe the further information given in the following sections as
necessary depending on the area of application.
To Next Page
Loading...
Need help?
General
