Time of day
This selection allows the clock to be
shown as 24 hours, 12 hours or not
at all. The time of day is also set
here.
If the clock is not selected the delay
start can only be shown as a 24 hour
timer. The display will show the timer
counting down until the start of the
program but not the current time of day.
Selecting the clock display
^ Select the desired clock display and
confirm.
The display shows the clock setting.
Set the time of day
^ Set the hours with the buttons +/–
and confirm with OK. Repeat with
setting the minutes and confirm. The
display changes to "Settings".
Display contrast
The contrast of the display can be
set at ten different levels.
It is factory set to Setting 4.
The contrast changes immediately
when a different level is selected.
Display brightness
The brightness of the display can be
set at ten different levels.
It is factory set to Setting 5.
The brightness changes immediately
when a different level is selected.
Settings J
57
To Next Page
Loading...
Need help?
General
