Warning and safety instructions
10
If the electrical connection cable is faulty it must only be replaced
by a Miele authorised service technician to protect the user from
danger.
The washing machine must only be connected to the on-site wa-
ter supply using a new hose kit. Old hoses must not be re-used.
Check the hose regularly for signs of wear. Replace it in good time to
avoid the risk of leaks and subsequent damage.
Faulty components must only be replaced by genuine Miele ori-
ginal spare parts. Miele can only guarantee the safety standards of
the machine when Miele replacement parts are used.
For reasons of safety, do not connect the machine to the mains
electricity supply by an extension lead, multi-socket adapter, or sim-
ilar. These can overheat and are a fire hazard.
In the case of commercial use, all relevant national provisions and
regulations (DGUV in Germany) relating to accident insurance are ap-
plicable to this machine. It is recommended to carry out testing in
accordance with national regulations (e.g. the regulatory framework
described in DGUV100-500/Chapter 2.6/Section 4). The test book
required for the documentation is available from Miele.
The machine must not be used in a non-stationary location (e.g.
on a ship).
Please observe the instructions in “Installation” and “Technical
data”.
If the washing machine is equipped with an electrical plug con-
nection, it must be easily accessible after installation so that the ma-
chine can be disconnected from the electricity supply if necessary.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
