Miele PWM 507 User Manual

Warning and safety instructions
9
Technical safety
 Before setting up the washing machine, check it for any externally
visible damage. Do not set up or use a damaged washing machine.
 The electrical safety of the washing machine can only be guaran-
teed when correctly earthed.
It is most important that this basic safety requirement is tested and
in case of any doubt the on-site wiring system should be inspected
by a qualified electrician.
Miele cannot be held liable for the consequences of an inadequate
earthing system.
 Unauthorised repairs could result in unforeseen dangers for the
user, for which the manufacturer cannot accept liability. Repairs
should only be undertaken by a Miele approved service technician,
otherwise any subsequent damage will not be covered by the war-
ranty.
 Do not make any alterations to the machine, unless authorised to
do so by Miele.
 The machine must be isolated from the electricity supply when
cleaning and maintaining the machine and in the event of a fault:
– switch off at the wall and disconnect the plug from the socket, or
– disconnect the fuse at the mains circuit board, or
– unscrew the on-site screw-in fuse.
See “Installation – Electrical connection”.

Miele PWM 507 Specifications

General

Drum capacity	7 kg
Delay start (max)	24 h
Spin-drying class	A
Maximum spin speed	1600 RPM
Noise level (spin)	72 dB
Noise level (wash)	- dB
Delayed start timer	Yes
Number of washing programs	-
Current	16 A
AC input voltage	400 V
AC input frequency	50 Hz
Energy efficiency scale	A to G
Water consumption per cycle	37 L
Energy consumption washing per cycle	- kWh
Door hinge	Right
Water fill	Cold, Hot
Drum volume	64 L
Control type	Rotary
Loading type	Front-load
Product color	White
Door opening angle	167 °
Appliance placement	Freestanding
Package weight	104000 g

Weight and Dimensions

Depth	714 mm
Width	605 mm
Height	850 mm
Weight	100000 g
Door diameter	300 mm