Problem solving guide
43
With the help of the following notes minor faults in the performance of the appli‐
ance, some
of which may result from incorrect operation, can be put right without
contacting the Service Department.
Repair w
ork to electrical appliances must only be carried out by a suitably
qualified person in strict accordance with current local and national safety regu‐
lations. Repairs and other work by unqualified persons could be dangerous.
The manufacturer cannot be held liable for unauthorised work.
Check indicators and fault messages
Problem Cause and remedy
The programme is can‐
celled, lights up
This is not a fault.
In some pr
ogrammes, if the drum has been underloa‐
ded or is empty, the programme will be cancelled.
This can also happen if the items are already dry.
Op
en and close the door to resume drying.
Dr
y individual items using the Warm air timed dry‐
ing programme.
flashes/lights up af‐
t
er the tumble dryer has
been switched on and a
programme cannot be
selected
Access via a code has been activated.
Se
e "Programmable functions - Code".
and (e.g. )
lig
ht up after a pro‐
gramme has been can‐
celled
No obvious cause.
Switch the dr
yer off and then on again.
S
tart a programme.
If the programme is cancelled again and an error
message
appears, there is a fault. Contact the Miele
Service Department.
To Next Page
Loading...
Need help?
General
