Installation and connection
53
Additional installation require‐
ments
F
or safety reasons the tumble
dryer must be disconnected from the
electricity supply before installation.
Building under a continuous work‐
t
op/in a row of kitchen units
It is very important to avoid a
build-up of heat. The warm air which
is expelled from the dryer must be
able to dissipate. Warm air which
cannot dissipate could cause a fault.
– The electrical socket must be located
in an accessible position near the ap‐
pliance.
– Drying durations may increase slight‐
ly
.
A build-up of heat can be avoided by:
– Adjusting the screw feet so that there
is a gap of at least 20 mm between
the floo
r and the bottom of the dryer.
– Creating a gap for the dryer in the
kitch
en furniture plinth facing.
– Creating ventilation gaps in the kitch‐
en unit.
Pushing the dryer under a worktop
This tumble dryer is suitable for push‐
ing
under a worktop if there is space to
do this without removing the lid.
Optional accessories
– Building-under kit
A b
uilding under kit is required if
the lid of the tumble dryer needs to
be removed in order to build it under
a worktop.
It must be installed/dismantled by a
suitably qualified fitter.
The lid of the tumble dryer is replaced
by the cover plat
e supplied with the
building under kit. It must be fitted by a
suitably qualified fitter to ensure electri‐
cal safety.
Fitting instructions are supplied with the
building-under kit.
– Washer-dryer stack
The tumble dryer can be combined with
a Miele washing machine in a washer-
dryer stack. The appropriate Miele
washer-dryer stacking kit is required.
– Plinth
The tumble dryer can be fitted on a
pli
nth with drawer (please note the
plinth may not be available in all coun‐
tries).
To Next Page
Loading...
Need help?
General
