MIMAKI APC-130 Quick Reference

- 11 -
When you cut off the sheet after cutting
There are two methods to cut off the roll sheet:
(1) By using the “automatic cutting function”, when cutting has been completed, cut off the
sheet automatically.
(For the “automatic cutting function” setting method, refer to the Operation manual chapter 3
“Setting the AUTO CUT”.)
(2) When you set the “automatic cutting function” to “OFF”, cut off the sheet manually with
the procedures below (paper cutting function).
 Paper cut function
Cut off the sheet on the current tool position.
When you use the paper cut function, the device
will cut up to 80mm from outside the pinch roller.
1
Press the key to select LOCAL
mode.
• Check that cutting (plotting) does not start even if you press the key and the
device enters into the remote mode in advance.
2
Press to enter into the
jog mode.
• When you press any jog key, the device enters into the jog mode.
3
By pressing , feed the sheet to the
position where you cut the sheet off.
: Moves the sheet to the rear side.
: Moves the sheet to the front side.
The cutter cuts the sheet while passing the position
described with the dotted line in the right photo. Move
the sheet to the position where you cut.
4
Press the key, and then press the
key.
• Cut the sheet off.
• When the cutting has been completed, the current mode returns to LOCAL mode.
• When you cut off the roll sheet in APC-130, use the cutter attached on the carriage.
Left pinch
roller
Right pinch
roller
Paper cut width
CUT1 20 050 0 . 30
0.0 0.0
Cut line
* * PAPER CUT * *
• When the pre-feed setting is valid, the pre-feed operation is performed and then the
device returns to the local mode.

MIMAKI APC-130 Specifications

General

Brand	MIMAKI
Model	APC-130
Category	Plotter
Language	English