Mimosa Client Help Content
Mimosa Clients Channel & Power
Copyright © 2014 Mimosa Page 47
Managing Channel & Power Settings
The Channel and Power Settings panel allows for either automatic or manual changes to frequency, channel width,
and power. When SRS (TDMA) is selected as the Wireless Protocol on the Link page, only the Power Override control
is available.
Source - The values on this page are inherited from the AP through wireless beacons.
●
Max Channel Width (MHz) - Select the maximum channel width (20, 40, or 80 MHz).
●
Center Frequency (MHz) - The center frequency of the channel used on the link. The center frequency
●
represents the absolute center of the selected channel width without any offset, and the center can be moved
in 5 MHz increments. The Channel will be automatically set by the AP, and not editable.
Tx Power (dBm) - Set the desired transmit power level. The allowed options are determined by a combination of
●
country and chosen frequency. If Auto Everything is set to On, the Channel & Tx Power will be automatically set,
and not editable.
Power Override - Allows Tx power changes from the value set by the AP through beacons.
●
AGC Mode - Use this feature to set the signal level below which the radio ignores incoming RF signals. The
●
choices are Off, Auto, or Manual.
AGC Minimum Rx Power (dBm) - In Manual mode, select an Rx power level below your expected signal, but
●
above other interference (-90 to -10 dBm).
Regulatory Domain - The country in which the device has been configured to run.
●
Note: Tx power selections may be limited based on your regulatory domain.
To Next Page
Loading...
Need help?
General
