Mimosa Client Help Content
Mimosa Clients Reset Process
Copyright © 2014 Mimosa Page 3
Local Device Reset
Product Applicability: C5, C5c
This process is to restore the device to the factory state when the device is physically available.
This process is to restore the device to the factory state when the device is physically available.
Follow these steps to reset the radio:
Disconnect the Ethernet cable from the radio.1.
Insert a paper clip into the hole next to the Ethernet port to depress the reset button (see image below).2.
Plug the Ethernet cable back in while holding the reset button down. The green LED will blink slowly after 23.
seconds, and then fast after 4 seconds.
Let go of the reset button when the green LED starts blinking fast.4.
The radio will then reboot for approximately 90 seconds.5.
Connect your computer to the LAN input of the PoE.6.
With a web browser, navigate to 192.168.1.20 (or address assigned by DHCP). The default password is7.
mimosa.
C5 Reset Button
To Next Page
Loading...
Need help?
General
