To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...Why is there no +5 VDC/+12 VDC output from my Mindray Medical Equipment?
If there is no +5 VDC/+12 VDC output: * Restart T1. If T1 does not turn on, replace the main board; this indicates a main board failure.
Why is my Mindray Medical Equipment touchscreen not responding?
If the touchscreen is not responding, the display may be defective, and you should replace the front housing assembly.
How to fix touchscreen accuracy issues on Mindray T1?
If the touchscreen accuracy is off, calibrate the touchscreen.
Why is the display blank or black on my Mindray T1 Medical Equipment?
If the display is blank or black, it could be due to: * A loose display connection cable. Properly connect the display connection cable. * A defective display. Replace the front housing assembly.
Why does my Mindray Medical Equipment report 'Storage Card Err'?
If a 'Storage Card Err' is reported, it indicates an SD card error. Restart T1. If the problem persists, format the SD card.
Why is there no analog out signal or defib. Sync signal from my Mindray T1 Medical Equipment?
If there is no analog out signal or defib. sync signal, it could be caused by: * Parameter board failure. Replace the parameter board. * Defective main board. Replace the main board. * Parameter connector board failure. Replace the parameter connector board. * Connection failure. Check that the connection between the main board and the parameter connector board is not damaged. * Failed analog out cable or defib sync. cable. Replace the cable.
Why is there no connection when my Mindray Medical Equipment is inserted into a Passport 12m or 17m patient monitor?
If there is no connection when inserted into a Passport 12m or 17m patient monitor, the infrared communication board may be defective. Replace the infrared communication board.
Why is the system time being reset on my Mindray Medical Equipment?
If the system time is being reset, it could be due to: * Backup battery failure. Replace the backup battery. * A faulty charging circuit for the backup battery. Replace the infrared communication board. * A defective main board. Replace the main board.
Why is there no video output from my Mindray Medical Equipment?
If there is no video output, it may be caused by: * A defective Dock interface board. Replace the Dock interface board. * A defective Dock converter board. Replace the Dock converter board. * A defective main board of the Docking Station. Replace the main board of the Docking Station.
What to do if the lock/unlock switch does not respond on my Mindray Medical Equipment?
If the lock/unlock switch does not respond, the main board may be defective. Replace the main board.
General| Category | Patient Monitor |
|---|---|
| Battery Life | Up to 4 hours |
| Imaging Modes | Not applicable |
| SpO2 | Yes |
| Pulse Rate | Yes |
| ECG | Yes |
| NIBP | Yes |
| Temperature | Yes |
| Parameters | ECG, SpO2, NIBP, Temperature, Respiration |
| Connectivity | USB, Ethernet, Wi-Fi |
Details on warnings, cautions, and notes for safe operation and handling of the patient monitor.
Procedures for upgrading the monitor's hardware, including IBP, ECG, and Wi-Fi functions.
Procedures for various performance tests including ECG, SpO2, NIBP, and others.
Tests for power-on, touchscreen calibration, battery, and network printing functionality.
Steps to access and utilize the factory maintenance menu for advanced settings.
Guide to identifying and resolving common problems with the patient monitor.
Specific tests and limits for electrical safety inspection as per standards.
