INSTALLING MIVOICE MX-ONE HARDWARE, OVERVIEW
13 6/1531-ASP11301 Uen T2 2015-04-23
6 INSTALLING CHASSIS IN A CABINET
These chapters describes the installation of hardware components in the BYB 501
cabinet. The recommended installation order is from the bottom of the cabinet to the
top.
For details see doc 20/1531-ASP11301 Installing Chassis in a Cabinet
Depending on the configuration, some pieces of hardware can be pre-installed. There-
fore, some installation steps may be irrelevant. In that case, ignore the irrelevant step
and proceed to the next one.
It is recommended to install the hardware at the cabinet locations described in the
instructions. Although not recommended, it is possible to change the hardware place-
ment in the cabinet. In that case, the following constraints must be regarded:
• The batteries must be placed at the lowest position in the cabinet.
• The fan unit must always be installed directly above the 7U subracks.
• If two 7U subracks are mounted, they must be mounted closely, one above the
other, and with a fan unit on top.
Note: The instructions describe a hardware installation in the BYB 501 cabinet. When
installing the hardware in other type of cabinets, refer to manufacturer instruc-
tions.
6.1 OVERVIEW
The following flow diagram shows the installation procedure step-by-step.
To Next Page
Loading...
Need help?
General
