Technical Information
C/3
Opening screen
On entering the set-up utility a main menu screen appears. If there is
an associated sub-menu, or a further sub-menu available, then the
listed options have a preceding bullet, as shown below ;
•
System summary Information about the system.
Processor, memory, drives etc.
•
Devices and I/O ports The settings for serial, parallel ports,
IDE interfaces, HDD.
•
Date and time Change the system master clock
•
Security View or change access to HDD, user
and administrator passwords.
•
Start options Boot from A: or C:, keyboard speed,
POST speed etc.
•
Advanced set-up Change the cache settings, ROM
shadowing and other related topics.
•
ISA Legacy resources Register resources used by new ISA
expansion cards, memory, DMA,
interrupts etc.
•
Power management Change settings for the Low power and
Standby energy saving modes.
Save settings Saves any changes that have been made
Restore settings Restores all the settings to the values
that were in force when you entered
set-up, same as pressing F9
Load default settings Restores the settings to their default
(possibly blank) state.
Exit set-up Ends the session and starts the system
POST again. If you have changed any
settings you will be asked if you wish
to save the new settings.
To Next Page
Loading...
Need help?
General