FOR EMERGENCIES
8–26
N29C001a
5. Insert a new fuse of the same capacity
into the clip and insert the fuse at the
same place in the fuse box.
CAUTION
(1) If the newly inserted fuse blows
again after a short time, have the
electrical system checked and re-
paired by an authorized MITSUBI-
SHI dealer to find the cause and
rectify it.
(2) Never use a fuse with a capacity
larger than that specified or any
substitute, such as wire, foil, etc.;
doing so will cause the circuit wir-
ing to heat up and could cause
fire.
Replacement of lamp bulbs
EN10A-Ab
Before replacing a bulb, ensure the lamp is
off. Do not touch the glass part of the new
bulb with your bare fingers; the skin oil left on
the glass will evaporate when the bulb gets
hot and the vapor will condense on the re-
flector and dim the surface.
N10B296a
Bulb capacity
EN10BMDh
A bulb should only be replaced with a new
bulb of the same rating and type. The desig-
nation can be found on the base of the bulb.
Outside
1- Position lamps 4W (T4W). . . . . . . . .
2- Headlamps, High/low beam
60/55W (H4). . . . . . . . . . . . . . . . . . . .
3- Front turn-signal lamps
21W (PY21W). . . . . . . . . . . . . . . . . .
4- Side turn-signal lamps
5W (WY5W). . . . . . . . . . . . . . . . . . . .
5- Front fog lamps* 55W (H3). . . . . . . .
To Next Page
Loading...
Need help?
General
