If your VCR is this If your VCR is this
...enter this code ...enter this code
brand.., brand...
Mitsubishi (A) 01 Philips 03, 10, 11
Mitsubishi (B) 02 Quasar 03
Canon 03 RCA 08, 13, 20
Emerson 04, 05 Sanyo 14
Funai 06 Scot 15
GE 03 Sharp 16
Goldstar 07 Sony 17, 18
Hitachi 08 Sylvania 03, 10, :[1
JVC 09 Symphonic 06
Magnavox 03, 10, 11 Teknika 04, 06
Multitech 06 Toshiba 15
NEC 12 Totevision 07
Panasonic 03 Zenith 19
Philco 03, 10
<setting up the remote control to operate your cable box>
O Turn off your cable box.
Choose the layer using a select button on the remote control:
CABLE, VCR-A or VCR-B.
O While holding in the POWER button on the remote control,
enter the code number listed in the chart on the next page for
your brand of cable box. (If more than one code number is listed,
try the first one. If that code does not work, try the next one
until you find the correct code.)
O Release the POWER button.
O Press the POWER button again. Your cable box should turn on.
If the cable box turns on, your remote control is now set to
operate your cable box.
If your cable box does not turn on, repeat the instructions above,
trying each code number listed for your brand of cable box.
Getting Started 49
To Next Page
Loading...
Need help?
General
