• Using the Active AN Network Feature
This A/V Network is a special feature that makes it: easier to use
your television and your other A/V components together. When you
connect the A/V Network, you can point the remote control at the
television, and it will "pass" the remote control command to the
other components.
Additionally, you will gain even more benefits if you have a
Mitsubishi VCR equipped for the Active A/V Network. The Active
A/V Network allows you to perform many" of the commonly used
features of your system at the press of just one button.
This section will explain the various, features of the Active A/V
Network.
[>Important:
before you begin
You must have connected an A/V Network cable from the
Actiw_ A/V Network terminal of :your TV to the A/V Network IN
terminal of your VCR. See "TV+Mitsubishi products that have
A/V Network terminals," page 43.
• You must have connected your VCR to External 1 (EXT-1) of
your TV.
• You must have set your TV's "AJV Network" setting to "Active"
or "Basic." See "Setting the A/V Network," page 62.
• Your VCR's remote control switch (if any) should be set to
"VCR-A,"
• Your VCR's video mute setting should be turned ON.
what the Active AN Network does
The Active AN Network makes it easier and faster to use the
VCR's Quick Program and Play commands and the TV's PIP com-
mands.
When using the Active A/V Network, you should always point your
remote control at your television.
Using the Active A/V Network Features 91
To Next Page
Loading...
Need help?
General
