6 - 6
BASE UNIT AND EXTENSION CABLE6.
(4) Calculation examples
(a) Calculation of voltage drop on the main base unit
(b) Calculation of voltage drop on the extension base unit
V
Z = 0.006 0.27 (8 + 7 + 6 + 5 + 4 + 3 + 2 + 1) = 0.05832
(c) Voltage drop on the extension cable
V
C = 0.021 (0.27 8) = 0.04536
(d) Verification of the receiving port voltage
5.1 - 0.15372 - 0.05832 - 0.04536 = 4.8426(V)
Since the receiving port voltage is more than 4.75V, the above system is usable.
(5) To reduce the voltage drop
The following methods are effective to reduce the voltage drop.
(a) Change the installing position of the module
Install modules with large current consumption in order from slot 0 of the main
base unit.
Install modules with small current consumption to the extension base unit.
(b) Connect the base units in series
By connecting base units in series (connecting the extension cable to the left
side of the main base unit. Refer to this section (2), the voltage drop on the main
base unit can be ignored.
If the extension cable is long, however, the voltage drop through the cable may
be larger than that on the main base unit. Therefore, calculate the voltage drop
according to (3).
(c) Use a shorter extension cable
The shorter the extension cable is, the smaller the resistive value and the
voltage drop become.
Use the shortest extension cable possible.
V
K = 0.007 {0.32 + 0.05 (9 + 8 + 7 + 6 + 5 + 4 + 3 + 2) + (0.27 8) 9}
= 0.15372
To Next Page
Loading...
Need help?
General
