Mitsubishi MELSEC-A series User Manual

3. SPECIFICATIONS /MELSEC-A
Dacription
SSP? or AD71TU
Area for positlonlng start data
numbers, etc. (For X axlsl
Wrlte enabled when
both X-axis and Y-
axis BUSY signals
are off.
Deoends
on data
Area tor error reset
I tme
Wrlte enabled at any
Nrlte enabled
at any
tame
-
I
UnUd 1 -
Nrlte enabled when
30th X-axis and Y-
)xis BUSY signals
we off.
Area
tor positlonlng start data
numbers,
etc. (For Y axlsl
Depends on data
U nu red
768 to 387 1
3872 4g, 17 lntorrnatlon
3s RAM. Writing here is not Wrltedlsabled
IllOWed.
I
Yrlte dlsabled
Unused
X axis positioning data area der-
cribed
in Section 3.4.3 (Maximum
400 positions)
Wrlte enabled at any
tlrne
Data format as follows:
Posltioning informatlon:
2 bytes (16 bltsl
Posltionmg speed:
2 bytes (16 bots)
Dwell time: 2 bytar (16 blts)
Positlonmg address:
4 bytes (32 blts)
3lock transfer of
,oslttonlng data
'rom AGGPP to
9071
IS only en.
#bled when PC ready
;Ignal
IS off.
cribed
in Section 3.4.3 (Maximum
Y axis positioning data area des
400 positions)
Data format
as for X axis.
Wrlte enabled at any
t me
Parameter area explalned In Sec.
tion 3.4.1 (X axis)
tion 3.4.1 (Y axis)
Parameter area explalned
In See-
Wrlte only enabled
when PC ready slgnal
IS off.
Wrlte only enabled
when PC ready slgnal
IS off
Zeroing data area described
in
Section 3.4.2 (X axis)
Zeroing data area described
in
Section 3.4.2 (Y axis)
The above data may be read at any time.
Addresses are expressed
in decimal (1 address = 2 bytes (16 bits1
Fig. 3.22 Buffer Memory Map
3-30
IB IWI 66101-A

Mitsubishi MELSEC-A series Specifications

General

Brand	Mitsubishi
Model	MELSEC-A series
Category	Controller
Language	English