8-187
AP7131>admin(system.snmp.traps)> show
Description:
Shows SNMP trap parameters.
Syntax:
Example:
admin(system.snmp.traps)>show trap
SNMP MU Traps
mu associated : enable
mu unassociated : disable
mu denied association : disable
mu denied authentication : disable
SNMP Traps
snmp authentication failure : disable
snmp acl violation : disable
SNMP Network Traps
physical port status change : enable
denial of service : enable
denial of service trap rate limit : 10 seconds
SNMP System Traps
system cold start : disable
system config changed : disable
rogue ap detection : disable
ap radar detection : disable
wpa counter measure : disable
mu hotspot status : disable
vlan : disable
lan monitor : disable
DynDNS Update : enable
For information on configuring SNMP traps using the applet (GUI), see Enabling SNMP Traps on page 4-33.
show trap Shows SNMP trap parameter settings.
rate-trap Shows SNMP rate-trap parameter settings.
To Next Page
Loading...
Need help?
General
