8
Getting started
1. Plug the telephone line cord into the socket marked on the rear of the
base. Plug the other end of the telephone line cord into the telephone wall
socket.
2. Plug the power adaptor jack into the socket marked on the rear of the
base and the power adaptor into the mains power wall socket.
Installing and charging the handset
1. Remove the battery cover from the back of the handset and insert
the rechargeable Ni-MH battery cells supplied. Please note the '+' and
'-' markings inside the battery compartment and insert in the correct
direction.
2. Slide the battery cover back into place.
3. If you are charging the batteries for the first time, place the handset on the
base to charge for at least 16 hours continuously.
4. When the handset is fully charged, icon will appear steady on the
display.
Connecting the handset and charger
(for multi-pack only)
If you have purchased a multiple pack, you will need to carry out this process
for all the handsets and chargers.
1. Plug the power adaptor jack into the socket marked on the rear of the
charger and the power adaptor into the mains power wall socket.
1
2
Press down
Slide
To Next Page
Loading...
Need help?
General
