4-4 Programming Mode
4.0 Programming Mode
4.1 Introduction
This mode allows you to edit a number of features to enhance the use of this radio.
4.2 Entering Programming Mode
If the radio is turned on, turn it off. Press and hold the MON, and turn on the radio. A ringing tone is
heard, which indicates that the radio is in Programming Mode. The K indicator is displayed.
4.3 Exiting Programming Mode
To exit Programming Mode, turn off the radio.
4.4 Accessing Programming Mode Parameters
In Dealer ConÞguration, Programming Mode parameters are grouped into three main categories:
RW (Radio Wide), Channel (001 to XXX
1
) and VFO (Variable Frequency Operation).
Use + or - buttons, to move from one category to another.
RW ßà CH 001 ßà CH 002 ßà É ßà CH XXX
1
ßà VFO
NOTE: Radio operating in User ConÞguration is only restricted to RW parameters.
Once you have selected the category, and wish to view its parameters, use PTT or MON to move
from one parameter to the other, as shown in the next diagram.
1. XXX denotes the maximum number of channels supported by your radio model.
To Next Page
Loading...
Need help?
General
