Programming Mode 4-11
4.6 Editing Channel Parameters
Channel parameters only affect the channel where the parameters are modiÞed. They become
effective after you press PTT or MON.
TELNO-X Telephone
Number
16 charac-
ters consist
of 1,2, É, 9,
0, A, B, C,
D, *, # and
Pause.
Blank ¥ Up to nine telephone numbers can be programmed.
¥ Once programmed into the memory, phone number
can be speed dialed by pressing PTT, + and then X,
where X denotes the telephone number location.
¥ Pause can be entered by pressing * followed by #.
¥ Enter # 16 times, to completely erase entered code.
¥ Refer to "4.10.5 Programming an Phone Number/
Access Code/De-access Code" on page 22 for
details.
PL-XXXX PL/DPL
Display Type
PL-CODE,
PL-FREQ
PL-FREQ ¥ Select the display type of PL/DPL: FREQ and
CODE.
¥ If FREQ has been selected, then the PL and DPL
will be displayed in frequency and octal code format
respectively.
¥ If CODE has been selected, then the PL and DPL
will be displayed in Motorola code number format
(see "4.8 PL Frequencies and Codes" on page 18
and "4.9 DPL Codes" on page 19).
¥ Press + or - to select CODE or FREQ.
SIT-XXXX Scan Interval
Time
SIT-0250,
SIT-0500,
ÉÉ,
SIT-5000
SIT-0500 ¥ Scan Interval Time is the duration the radio will
spend on the landed channel before switching to
scan the Priority Channel in Priority Scanning.
¥ Unit is in ms. Scan Interval Time is therefore pro-
grammable from 250ms to 5000ms in 250ms steps.
¥ Press + or - to select the desired Scan Interval
Time.
SHT-XXXX Scan Hang
Time
SHT-0500,
SHT-1000,
ÉÉ,
SHT-9500
SHT-7000 ¥ Scan Hang Time is the duration the radio will stay
on the landed channel without detecting any activity
before it resumes scanning.
¥ Unit is in ms. Scan Hang Time is therefore pro-
grammable from 500ms to 9500ms in 500ms steps.
¥ Press + or - to select the desired Scan Hang Time.
Channel
Parameter
Description Range
Default
from
Factory
Remarks
CH-XX Channel On/
Off
CH-OFF,
CH-ON
CH-ON ¥ Select if the channel is enabled (ON) or disabled
(OFF).
¥ Disabled channel will not be accessible in Normal
Mode.
¥ Press + or - to select ON or OFF.
RW
Parameter
Description Range
Default
from
Factory
Remarks
To Next Page
Loading...
Need help?
General
