37
Base settings
4. Scroll U or D to
All Handsets
or
Select Handset
then press
Select
.
If you choose
Select Handset
, all available handsets are displayed.
• Scroll U or D to the handset you want then press
Select
.
• Scroll U or D to the number of rings that you want to set: 2, 4 or 6 and
press
Select
.
5. Press
n to return to standby mode.
9.5 To change the flash time
Flash is useful to access certain network services and PABX/switchboard
services.
The default flash time preset in the phone is suitable for your country network
and therefore you should not need to change it.
Note
The use of the phone cannot be guaranteed on all PABX.
1. Press
Menu
, scroll D to
Settings
and press
Select
.
2. Scroll
D to
Set Base
and press
Select
.
3. Scroll
D to
Flash Time
and press
Select
.
4. Scroll
U or D to
Flash 1
or
Flash 2
then press
Select
to confirm.
5. Press
n to return to standby mode.
9.6 To change the System PIN
The System PIN is required when changing certain settings and for registration
/ de-registration. The default setting is 0000. You can change this to your own
preferred number (up to 8 digits).
When you enter a PIN, the digits are shown as ********.
1. Press
Menu
, scroll D to
Settings
and press
Select
.
2. Scroll
D to
Set Base
and press
Select
.
3. Scroll
D to
System PIN
and press
Select
.
4. Enter the old PIN (Default setting = 0000) and press
OK
.
5. Enter the new PIN and press
OK
.
6. Re-enter the new PIN and press
OK
.
7. Press
n to return to standby mode.
Note
It is advisable to make a note of your new PIN code and keep it somewhere
safe.
To Next Page
Loading...
Need help?
General
