52
PROGRAMMING FEATURES
GEOGRAPHIC FILTER
There are maximum of six geographic codes can be
programmed. When all fields are unselected, or any of
the geographic code is “ALL” for both State and
County code (FIPS is “000000”), the radio bypasses
the Geographic Filter check.
There are two ways to enter the geographic code,
• Select State and County Code
• Enter the FIPS code directly (must be 6 digits)
STATE
Selects the State, Territory and Offshore (Marine
Area) portion (SS) the radio alerts for.
COUNTY
Select a county, province, or major metropolitan area
(CCC) the radio alerts for.
FIPS
Federal Information Processing Standards (FIPS)
contains six digits which represent PSSCCC, where P
is the region code, SS is the state code and CCC is
the county code.
Enters/Edits a specific FIPS whenever it is necessary.
Further information about FIPS can be found on the
Internet at www.nws.noaa.gov/nwr/ indexnw.htm or
call the National Weather Service Toll-Free Number
SAME county code – 1888-NWS-SAME (1-888-697-
7263).
CLONING RADIOS
You can clone RDX Series radio profiles from one
Source radio to a Target radio by using any one of
these three methods:
• Using a Multi Unit Charger (MUC- optional
accessory),
• Using two Single Unit Chargers (SUC) and a
Radio-to-Radio cloning cable (optional
accessory),
• the CPS (free software download)
MN002895A01_final.book Page 52 Thursday, January 5, 2017 10:51 AM
To Next Page
Loading...
Need help?
General
