Chapter 2
Device Care
This section describes the basic handling precaution of the device.
Table 2: IP Specification
IP Specification Description
IP67 Allows your device to withstand adverse field
conditions such as being submersed in water
between 15 cm and 1 m for 30 minutes or dust
tight for 2–8 hours.
• If your device has been submersed in water, shake your device and wired earpiece well to remove
any water that may be trapped inside the speaker and microphone port. Trapped water could cause
decreased audio performance.
•
Never poke the vent (hole) located on the device back casing on top of the battery compartment.
This vent allows for pressure equalization in the device. Doing so may create a leak path into your
device, and your device's submersibility may be lost.
• Never obstruct or cover the vent, even with a label.
• Ensure that no oily substances come in contact with the vent.
• Your device is designed to be submersible to a maximum depth of 1 m (3.28 ft) and a maximum
submersion time of 30 minutes. Exceeding either maximum limit or use may result in damage to
your device.
• When cleaning your device, do not use a high-pressure jet spray on device as this will exceed the 1
m depth pressure and may cause water to leak into your device.
2.1
Cleaning and Disinfecting Your Device
NOTE: Ensure the battery cover and SIM card slot are properly attached to the device during
cleaning and disinfecting task.
Cleaning Your Device
Prerequisites: Ensure that you have the following items:
•
Gloves or other PPE as applicable
• Detergent
• Water
• Dish cloths
• Stiff, non-metallic, and short bristled brush
• Soft, absorbent, and lint-free cloths
Procedure:
1 Mix a 0.5 % detergent-water solution.
MN009911A01-AA
Device Care
11
To Next Page
Loading...
Need help?
General
