Chapter 13
Emergency Operations
Emergency Alerts are used to indicate critical situations. You can initiate an Emergency Alert at any
time even when there is activity on the current Talkgroup.
During the Emergency mode, any call launched is declared as Emergency Call.
13.1
Declaring Emergency
Procedure:
To declare emergency locally, press and hold the Emergency button.
Your device shows the following indications:
•
The device vibrates.
• The Emergency Alert tone sounds.
• The voice announcement sounds.
• The bar LED shows six bars after countdown ends.
• The top and bottom crescent amber LED blinks twice.
You can release the Emergency button during the countdown to stop the process.
NOTE: You can also declare an Emergency remotely by an authorized user or a dispatcher, but
there is no countdown on the device LED bar if done remotely.
If Emergency is declared successfully, your device shows the following indications:
•
The Emergency Alert tone sounds.
• The voice announcement sounds.
• The top and bottom crescent amber LED illuminates.
NOTE: When the device is in Emergency mode, you are only allowed to control the volume
make an emergency call and exit the emergency mode.
If Emergency fails to declare, your device shows the following indications:
•
The Emergency Declare Fail tone sounds.
• The voice announcement sounds.
• Returns to the previously selected talkgroup.
13.2
Canceling Emergency
Procedure:
To cancel emergency locally, press and hold the Emergency button.
Your device shows the following indications:
• The device vibrates.
• The voice announcement sounds.
MN009911A01-AA
Emergency Operations
45
To Next Page
Loading...
Need help?
General
