5.2
Initiating Voice Assistant
Voice Assistant allows you to manage your device and perform information lookups using voice
commands.
NOTE: This feature can only be used with a wired or Bluetooth accessory.
Prerequisites: Ensure an accessory is connected.
Procedure:
1 Press the Voice Assistant
button.
2 After you hear a tone, speak your command into the accessory microphone.
5.2.1
Voice Assistant Commands
The following commands are examples you can use to operate the device.
There are no specific commands. You may speak your intended commands in approximate terms.
NOTE:
•
Acceptable voice commands can be configured in the WAVE PTX Portal.
• To end the current voice assistant session, speak “"Cancel"” or “"Nevermind"”.
Features Command Examples
Private Call
• “Call Tom”
• “Contact Tom”
Group Call
• “Switch to Housekeeping”
• “Call Housekeeping”
Lock and Unlock PTT button
• “Lock PTT”
• “Unlock PTT”
DND
• “Set status to DND”
• “Set status to Available”
Battery Status
• “Battery level”
• “Check battery status”
Volume
• “Increase volume”
• “Decrease volume”
• “What is my volume”
Time
• “What is the time”
• “Current time”
Bluetooth
• “Turn on Bluetooth”
• “Turn off Bluetooth”
MN009911A01-AA
Chapter 5 : Basic Device Operation
26
To Next Page
Loading...
Need help?
General
